I then removed and checked the reed switch in front of the inlet impeller and that has continuity when I put a magnet near it. It then stops for a minute or two and starts filling again, it keeps doing this until it floods, trips the float switch, and drains again.I ran the diagnostic test and it says it's not getting any water, but it's the opposite it's getting too much water.So I checked the inlet impeller- which is spinning fine. What seemed to be happening is the machine is draining then filling. I cleared the water in the lower tray and restarted the machine. I looked for leaks in the pipe I had unblocked but it seemed alright. I took the lower panel off and it had some water in it causing the float/flood switch to engage. I cleared the block and the dishwasher worked again for 2 or 3 washes.It then got stuck on drain again. Our Dishwasher didn't drain so I took of the lower panel and saw a blocked pipe from the sump.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |